![]() No one technique covers all situations and you have to adapt to the task at hand. ![]() For holes or internal profiles I tend to do what GregSY posted above. This is what I do for flat work or blending. Hope this helped someone, other techniques are equally valid. Polishing with felt bobs was done much the same way. For me, climb cutting/grinding had to be very light finishing passes or it would leave marks on the surface. It may seem to take longer this way but firm control avoids the burr snagging/jumping and chipping a good carbide burr. If it was a long bead of weld I'd just re-position my forward hand/anchor in a series of horizontal cuts. I always tried to keep the cutter/burr/wheel moving to create flat surfaces that could be disengaged from at any point if something didn't feel right, always cutting/grinding conventional. ![]() Just pressing the burr/wheel into the work at one place creates a radius and that always seemed to snag the cutter or generate too much heat. The perfect combination of tungsten carbide, shape and cut geometry and, if required, coatings, makes this possible. Carbide Burrs also known as Die Grinder Bits are designed for machining materials of virtually any strength. Using the forward hand as a pivot I would use the rear hand to sweep across the area parallel to the surface like I was a horizontal mill. For help choosing the correct Abrasive for your application, please call (800) 608-5210 or email. Gloves on the forward hand are important to avoid the shower of "needles" and absorb some of the vibration that will transfer into the work. The back hand controls the trigger AND the back end of the grinder. The forward hand, palm up, plant the knuckles (back of hand) firmly on the work as an anchor/shock absorber/pivot. For most work I always had the forward hand firmly grasping the grinder, mindful of where the exhaust jets were if it's pneumatic. Milwaukee Cordless Tools Milwaukee Combo Kits Milwaukee M12 & M18 Milwaukee Angle Grinders Milwaukee Air Compressors. It is about technique and everybody has one. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |